What F67 means on your Asko dishwasher (asko dishwasher f67)
An asko dishwasher f67 code is a current-display failure reading out as “Water inlet problem 2.” As with the two overfilling codes, Asko documents two separate water-inlet problems on this generation, F12 and F67, which points to the fill-monitoring logic checking for a fill shortfall at more than one stage of the cycle rather than one single check. In practice both problems share the same underlying troubleshooting: confirm supply, pressure, and the inlet screen before assuming a valve or sensor has failed.
Symptoms
These signs are what tell this condition on your Asko dishwasher apart from lookalike problems that need a different fix. Your dishwasher might present one clue or several at once, either building up gradually or appearing abruptly after a power interruption, a hard cycle, or recent handling.
- The display shows F67 or a water inlet error message
- The fill phase takes noticeably longer than usual before the problem appears
- Little water sound is heard entering the tub relative to a normal fill
- The problem has appeared after other fixtures in the home also showed reduced water pressure
Common causes
Different underlying problems can surface the same way on your Asko dishwasher, so the causes below run in order of probability. Clearing them one by one separates a quick check on the dishwasher from a repair that genuinely needs trained service and genuine parts.
- Partially closed shutoff valve — the valve behind or under the sink is not fully open
- Clogged inlet filter screen — sediment buildup is restricting flow at the fill fitting
- Reduced household water pressure — pressure at the fixture is too low to complete a normal fill cycle
- Flow sensor failure — the sensor counting incoming water is not registering correctly even with normal flow
Troubleshooting steps you can try
Try these checks on your Asko dishwasher in the order given before you call for service, since the early ones often settle the matter. Stop the moment you are unsure, or where mains voltage, gas, a hot cavity, water, or a sealed component is involved on the dishwasher, and leave the rest to a qualified technician.
- Confirm the shutoff valve feeding the dishwasher is fully open.
- Check water pressure at a nearby faucet for comparison.
- Rinse the inlet filter screen at the fill fitting if it is reachable without tools.
- Run a short cycle afterward to see whether the fill completes normally.
Parts a technician may replace
Expect a technician to inspect, test, or replace the inlet valve, inlet filter screen, and flow sensor on your Asko dishwasher, depending on what the diagnosis shows. Each part is matched to the dishwasher by model, serial, and Art. No., and genuine OEM or trusted-supplier components are fitted to the dishwasher rather than generic ones, so the fix holds.
When to call a technician
A second water inlet problem that persists after supply and screen checks needs an experienced technician to test the inlet valve and flow sensor. Because the severity is Medium, you can take your time with your Asko dishwasher; if F67 returns on the dishwasher after these steps, though, have a technician verify the cause rather than guessing at parts. Your Asko dishwasher is handled independently — we have no affiliation with Asko, Gorenje, or Hisense — by experienced technicians using genuine OEM or trusted-supplier parts, with 30 days of labor warranty on the dishwasher. When you schedule service for your Asko dishwasher, quote its model, serial, and Art. No. — that way the correct part is matched to the dishwasher beforehand and F67 is put right in as few visits as possible.
Related help and Asko resources
If F67 has not cleared on your Asko dishwasher, you can book Asko dishwasher repair, browse our dishwasher error-code guides, put our step-by-step repair guides to use, schedule service for service, or locate help on our locations page. Full product details for your Asko dishwasher live on the manufacturer’s site at us.asko.com.
