What E10 means on your Asko washer (asko washer e10)
An asko washer e10 code on the WM75/PMCU platform is a water level sensor error — the control cannot get a reliable reading from the sensor that tracks how full the drum is. This is a different problem from E11 immediately after it in the manual’s table, which is a confirmed overflow condition rather than a sensor communication problem. E10 can appear well before the drum is actually overfull, simply because the control has lost trust in the sensor’s reading.
Symptoms
The signs collected here distinguish this problem on your Asko washer from other conditions that can look the same. Your washer might show them individually or in a cluster, appearing gradually or suddenly after an outage, a spill onto the controls, or recent service work.
- E10 shows on the display, sometimes before any fill has completed
- The cycle may pause at an unexpected stage
- Water level in the drum may not match what the display or program suggests
- The problem can appear even on a normally sized load
Common causes
Your Asko washer can show these signs for any of several reasons, so weigh the probable causes before the rare ones. Going through them in sequence separates something you can settle yourself on the washer from a repair that wants trained service and proper parts.
- Sensor tube blocked or kinked — the small air tube feeding the pressure sensor is obstructed
- Sensor failure — the pressure sensor itself has drifted or failed
- Wiring failure — a damaged connection between the sensor and control board
Troubleshooting steps you can try
Take these checks in sequence on your Asko washer before booking, as the simplest ones resolve a surprising number of problems. Stop at any step on the washer that brings you close to mains power, gas, a hot oven, water, or a sealed component, and call a qualified technician.
- Power-cycle the washer and try the program again once.
- Avoid repeatedly restarting if E10 returns immediately, since a true sensor failure will not clear with a reset.
- Note whether the problem coincides with a specific program or load size.
- Book service rather than continuing to run loads with an unreliable level reading.
Parts a technician may replace
A technician diagnosing your Asko washer may inspect, test, or replace the water level (pressure) sensor, sensor tube, and wiring harness, depending on which one has actually failed. Reading the washer’s model, serial, and Art. No. before ordering avoids replacing more of the washer than the problem requires, and keeps the fitted part an exact match.
When to call a technician
E10 needs an experienced technician to test the water level sensor, its tube, and its wiring on your Asko washer. At Medium severity your Asko washer can wait for a convenient appointment; still, E10 recurring on the washer once you have finished the steps is best confirmed by a technician before parts are changed. We are not affiliated with Asko, Gorenje, or Hisense; your washer is repaired independently by experienced technicians with genuine OEM or trusted-supplier parts and a 30-day labor warranty. When you book, have your Asko washer’s model, serial, and Art. No. to hand so the exact part for your build is matched before the visit and E10 is put right in as few trips as possible.
Related help and Asko resources
Should E10 persist on your Asko washer despite the steps above, you can book Asko washer repair, read more of our washer error-code guides, follow our step-by-step repair guides, schedule service for a visit, or locate a technician through our locations page. A related condition on your Asko washer is covered under E11 overflow. Manufacturer documentation and specifications for your Asko washer are hosted at us.asko.com.
